Services
Services
Explore reliable heating, cooling, and refrigeration services for homes and businesses in Benson and Tucson, AZ, from Abbey Aire and Building Repair.

RESIDENTIAL HEATING & COOLING

Air Conditioning Repair
Warm air, weak airflow, tripped breakers, and ice on the line set all trace back to something measurable. We put gauges and a meter on the system, find the actual fault, and repair it the same visit whenever parts allow.
Air Conditioning Installation
Sizing comes first. A Manual J load calculation, a matched Manual S selection, and duct work checked against Manual D decide whether your new system holds temperature in July or short cycles all summer.
AC Replacement
15 years is the median service life of a split system, and desert duty shortens it. When repair costs start stacking, we lay out replacement options against the Southwest efficiency minimums and let the numbers decide.
AC Maintenance & Tune-Ups
Coil fouling doubles evaporator pressure drop in about 7 years, and monsoon dust accelerates it. Seasonal tune-ups clean both coils, verify charge and airflow against design, and catch the small failures before July finds them.
Heating Repair
Cold air from the vents, a system that will not start, or short cycling every few minutes points at ignition, control, or airflow faults. Diagnosis starts at the thermostat and follows the sequence of operation to the failure.
Heating Installation & Replacement
Benson sits near 3,589 feet, which means gas input has to be derated and the right orifice kit installed. New heating systems get sized, vented, and commissioned to that altitude rather than to a catalog number.
Furnace Repair
Yellow burner flame, soot on the exchanger, or a chemical odor during operation are inspection findings, not opinions. Every furnace repair includes a combustion and heat exchanger check before we sign the system back over.
Heat Pump Repair & Installation
Tucson winters sit above the balance point of a properly sized heat pump, so one machine covers both seasons here. Repairs cover reversing valves, defrost boards, and the auxiliary heat staging that Benson mornings actually use.
Mini Split Install, Repair & Replacement
Line set length, height difference, and weighed-in charge decide whether a ductless system performs. Installations are evacuated to 500 microns and held there, then charged per foot rather than by gauge pressure and guesswork.
HVAC Maintenance
Ducts in a typical home leak 20 to 30 percent of the air moving through them. Whole-system maintenance measures airflow, checks static pressure, changes filters on a desert schedule, and documents what changed since last season.
Emergency HVAC Repair
An indoor failure in July is a health problem before it is a comfort problem, especially for older adults and pets. Urgent calls get triaged by risk, and we carry the common failure parts on the truck.
COMMERCIAL HVAC

Commercial HVAC Repair
Field surveys of western rooftop units found economizer faults in 64 percent and airflow problems in 42 percent. Commercial repairs start with those two, because they hide behind a unit that still appears to run.
Commercial HVAC Installation
Packaged units, curb adapters, crane sets, and sealed mechanical plans are all part of a commercial changeout. We coordinate the lift, the permit package, and the tie-in so the building loses the least possible time.
Commercial HVAC Maintenance
Standard 180 sets the floor: filters checked quarterly, belts and economizer dampers twice a year, coils and refrigerant circuits annually. Scheduled agreements put your rooftop equipment on that calendar with written documentation each visit.
Commercial Air Conditioning Repair
A sales floor that will not hold temperature costs traffic every hour it stays warm. Compressor amperage, condenser airflow, and economizer position get checked against nameplate data before anything is condemned or replaced.
COMMERCIAL REFRIGERATION

Commercial Refrigeration Repair
Cold holding is 41 degrees or below, and product above 41 starts a clock an inspector can read. Refrigeration calls get temperature logged at multiple points, then traced to charge, defrost, airflow, or door seal.
Walk-In Cooler Repair
Door infiltration accounts for more than half a walk-in's cooling load, and at 115 degrees outside a propped door empties the box in minutes. Repairs cover gaskets, closers, evaporators, defrost timing, and condensing units.
Reach-In Cooler & Freezer Repair
Under-counter and upright units fail quietly because nobody watches them until product softens. Condenser cleaning, fan motors, defrost heaters, control boards, and worn gaskets cover most of what goes wrong in a self-contained cabinet.
Commercial Freezer Repair
A full freezer holds safe temperature roughly 48 hours with the door shut, which is the entire window you have. Ice buildup, failed defrost heaters, short cycling, and low-temperature charge faults are the usual causes.
RESTAURANT & FOOD-SERVICE EQUIPMENT

Commercial Ice Machine Repair
Manufacturers report that roughly 70 percent of ice machine problems trace back to water. Tucson water runs hard, so scale removal, filtration, and sanitizing sit at the center of every service and repair we perform.
Commercial Cooking Equipment Repair
Hot holding is 135 degrees or above, and a fryer or oven drifting off setpoint becomes a food safety issue fast. We repair burners, thermostats, igniters, controls, and the gas connections behind the line.


